Cobalt-digital COMPASS 9035 Analog and SDI Input to SDI Output Co Bedienungsanleitung PDF herunterladen (Seite 37)

9035-OM (V4.4) 9035 PRODUCT MANUAL 2-5

Installation and Setup Installing a Rear I/O Module

Figure 2-2 Rear I/O Module Installation

9035 Rear I/O Modules

Table 2-1 shows and describes the full assortment of Rear I/O Modules

specifically for use with the 9035.

Note: Rear I/O Modules equipped with 3-wire Phoenix connectors are supplied with

removable screw terminal block adapters. For clarity, the adapters are omit-

ted in the drawings below.

DSCN3483A.JPG

Align and engage mounting tab on Rear

I/O Module with the module seating slot

on rear of frame chassis.

Hold top of Rear I/O Module flush against

frame chassis and start the captive screw.

Lightly tighten captive screw.

DSCN3487A.JPG

Note: Rear I/O Modules RM20-9035-C, -D, -E, and -F occupy two

rear module slot mounting locations and use two captive

screws.

Rear I/O Module RM20-9035-G occupies three rear module

slot mounting locations and uses three captive screws.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 105 106

Keine Kommentare

Cobalt-digital COMPASS 9035 Analog and SDI Input to SDI Output Co Bedienungsanleitung Seite 37